Trim, cut and convert audio in your browser

Compress Audio File

Pick a smaller format or bitrate and check the new size before saving.

Free · runs in your browser · nothing is uploaded

Open on Tone Snip

This embed was switched off for this website. Open on Tone Snip

Want this audio tool on your own site? The embed code is on the about page. Embed code

To compress an audio file, re-save it in a smaller format or at a lower bitrate and check the estimated size before you convert. The save panel shows the size of the result for your file’s length and updates it as you change the format, bitrate, sample rate or channels, so you can adjust until it fits an email, an upload limit or a phone’s storage. This is lossy compression, which is different from the Audio Compressor page that evens out loud and quiet parts. The page opens MP3, WAV, OGG, M4A, AAC, FLAC, AIFF and Opus files, and saves OGG Vorbis, M4A, MP3, FLAC or WAV.
Compress audio file example

How to make an audio file smaller

  1. Press Choose audio file, or drop a file onto the page, and wait for the waveform.
  2. If only part of the recording is needed, drag across the waveform to select it. Only the selection is saved, and less audio means a smaller file.
  3. In the Save panel, open the Format list and choose OGG Vorbis or M4A. The page opens on OGG Vorbis; WAV is the largest option.
  4. Set Quality to Small file for OGG, or Bitrate to 64 or 96 kbps for M4A. M4A appears only in browsers that can encode AAC, such as Chrome, Edge and Safari 26 or later.
  5. For speech, set Sample rate to 22050 or 16000 Hz and Channels to Mono.
  6. Read the Result line above the Save button. It gives the length and the estimated size. Adjust the settings until it fits.
  7. Press the Save button, check the result in the small player, edit the file name if you like, and press Download.

Work from your original file when you can, because compressing an already compressed file loses a little more each time. Press Play to check the selected part before you save, since the preview plays the original sound, not the compressed result.

After saving, compare the size shown in the result panel with the estimate. If it is still too large, go back to the Save panel, lower the bitrate or quality, or select a shorter part, and save again without reloading the file.

How do I reduce the size of an audio file?

Change the format, the bitrate, the sample rate or the number of channels. The biggest saving comes from switching from WAV or FLAC to a lossy format at a low bitrate, and the next from using mono instead of stereo. A lower sample rate helps most with speech, where 22050 or 16000 Hz is enough.

Trimming away parts you do not need before converting also reduces the size, since every second of sound costs bytes. On this page you can do that by selecting the part to keep on the waveform. The Silence Remover can shorten a speech recording further.

File size is roughly the bitrate multiplied by the length, divided by 8 to turn bits into bytes. A 30-minute recording at 64 kbps comes to about 13.7 MB, and at 128 kbps to about 27.5 MB, with 1 MB counted as 1,048,576 bytes. A higher bitrate keeps more of the original sound and makes a larger file.

Can the smaller file be an MP3?

Yes, MP3 is in the Format list at a constant 128, 192, 256 or 320 kbps, and 128 kbps makes a 10-minute stereo file of about 9.2 MB. MP3 has no setting below 128 kbps here and is always 32 kHz or more, so the smallest files still come from OGG at the Small file preset or M4A at 64 kbps. Re-saving an MP3 at a lower bitrate re-encodes it, which loses a little more detail.

Which settings suit speech?

Speech needs far less data than music. Mono, a sample rate of 22050 or 16000 Hz and the Small file preset or a low M4A bitrate usually give a very small file that is still clear. Music keeps more detail at a higher bitrate, so check the saved result by ear.

Does compression reduce quality?

Yes, for MP3, OGG and M4A. The sound that is removed cannot be restored, and re-encoding a file that is already compressed loses a little more. FLAC is the exception: it makes a WAV smaller without any loss, but it cannot get as small as a lossy file.

How much smaller can the file get?

The result depends on the format and bitrate you pick. A 10-minute stereo recording is about 101 MB as 16-bit WAV, about 6 MB as OGG at the Small preset and 4.6 MB as M4A at 64 kbps. Mono halves most of these. The table covers the options in the save panel (1 MB = 1,048,576 bytes).

Option10-minute stereo10-minute mono
WAV 16-bit 44.1 kHz101 MB50.5 MB
WAV 16-bit 16 kHz (speech)36.6 MB18.3 MB
OGG Small file5.8 MB4.5 MB
OGG Balanced7.8 MB5.1 MB
M4A 128 kbps9.2 MB9.2 MB (same bitrate)
M4A 64 kbps4.6 MB4.6 MB (same bitrate)
MP3 128 kbps9.2 MB9.2 MB (same bitrate)

Frequently asked questions

How can I compress an MP3 audio file?

Open the MP3, choose MP3 at 128 kbps if it has to stay an MP3, or OGG Vorbis at the Small file preset or M4A at 64 or 96 kbps for a smaller file, and save. Any of these re-encodes the sound.

Can I compress an audio file to a set size like 16 MB?

There is no target-size box, but the line above the Save button shows the estimated size as you change the settings. Lower the bitrate, switch to mono or select a shorter part until the estimate fits.

Can I compress WAV or FLAC without losing quality?

Only with FLAC, which stores the same sound in about half to two thirds of the WAV size. OGG and M4A are smaller still but lossy.

Is my file uploaded, and do I need an account?

No account is needed. The file is read and re-encoded inside your browser and never leaves your device.

Why compress audio?

Uncompressed audio takes a lot of space and is awkward to email or store on a phone. A lossy format brings the same recording down to a fraction of the size.

Which formats can I open, and is there a size limit?

MP3, WAV, OGG, M4A, AAC, FLAC, AIFF and Opus open, up to 600 MB on a computer and 150 MB on a phone. A browser that cannot play a format shows an error.

Can I compress audio on my phone?

Yes, in a phone browser. About 15 minutes of decoded stereo audio fits in memory there, against about 60 minutes on a computer.

Does compression change the sample rate or channels?

Not unless you ask. The source sample rate is kept and mono stays mono. The Save panel lets you lower either to save space.