Trim, cut and convert audio in your browser

Ringtone Maker

Choose the part of a song you want to hear when the phone rings.

Free · runs in your browser · nothing is uploaded

Open on Tone Snip

This embed was switched off for this website. Open on Tone Snip

Want this audio tool on your own site? The embed code is on the about page. Embed code

A ringtone maker cuts the part of a song you like into a short clip and saves it in a file type your phone can use. Here you open an MP3, M4A, WAV, OGG or FLAC file, drag across the waveform to choose the section, and save it as M4R for an iPhone, or as M4A, OGG or WAV. A short fade in (0.3 seconds at first) and fade out (1 second) keep the clip from starting and stopping abruptly, and you can change both from 0 to 5 seconds. A note under the controls reminds you that Apple’s help gives 30 seconds as the longest iPhone ringtone and warns when your selection runs past it. Songs protected by copyright stay your own responsibility.
Ringtone maker example

Cutting a ringtone from a song

  1. Press Choose audio file and select a song you already have, or drop it onto the page. Try a sample loads a demo clip.
  2. A starting selection of up to 20 seconds appears on the waveform. Drag its handles, or drag across the waveform, to cover the part you want. The Start, End and Length boxes take exact times, and Start here and End here use the playhead.
  3. Press Play to hear the selection, and Loop if you want it repeated.
  4. Check the note under the controls. If it turns into a warning, shorten the selection to 30 seconds or less.
  5. Set Fade in and Fade out.
  6. In Save, pick a Format: M4R (iPhone ringtone, AAC), M4A (AAC), OGG Vorbis or WAV. For the AAC formats choose a Bitrate from 64 to 256 kbps.
  7. Press Save as M4R (or the name of the format you picked) and wait for the progress bar. Cancel stops it.
  8. Press Download once “Ready.” shows.

Tip: start the selection a moment before the first beat so the ringtone does not begin in silence. The Save button stays off until a selection exists.

Use Loop while moving the handles: it replays the selection so you hear exactly where the ringtone will start and stop. A ringtone that begins with a hard cut can sound abrupt, which the fade in avoids.

How do I make a ringtone online?

Open a song, select the part you want on the waveform and save it as a short audio file. The cutting happens in your browser. The remaining steps, getting the file onto the phone and picking it as the ringtone, happen on the phone and differ for iPhone and Android.

How long can an iPhone ringtone be, and why 30 seconds?

Apple’s help gives 30 seconds as the longest iPhone ringtone, and GarageBand can shorten a longer clip automatically. That is why this page checks your selection and warns when it is longer. Android has no single limit on these pages; a clip of 20 to 30 seconds is common because a phone stops ringing after a while.

Which format should I save the ringtone in?

M4R is AAC audio with the .m4r extension, the file type iPhone ringtones use. M4A holds the same AAC with the usual extension. Apple documents GarageBand as the way onto an iPhone, and a clip saved as M4A can be added from the Files app. OGG and WAV suit Android, which accepts MP3, M4A, OGG and WAV. M4R and M4A are available only in browsers that can encode AAC, and the page hides them otherwise.

Can I add a fade-in or fade-out?

Yes. Both fades are applied to the saved clip. Longer fades suit a gentle tone, while zero keeps a hard start. The two fade controls run from 0 to 5 seconds, and a fade shrinks if the two together would be longer than the clip.

Will cutting affect the sound quality?

Saving as WAV adds no compression loss. M4R, M4A and OGG are lossy, so the clip is encoded again, and a lower bitrate or the Small file preset discards more. A higher bitrate keeps more of a source that is already lossy.

How big is a ringtone file?

A ringtone is short, so the file is small. At 128 kbps AAC a 30-second ringtone, the longest that the Apple help pages allow for an iPhone, is about 0.46 MB and a 15-second one about 0.23 MB. The table gives sizes for other lengths and bitrates (1 MB = 1,048,576 bytes).

Length64 kbps128 kbps256 kbps
15 s0.11 MB0.23 MB0.46 MB
20 s0.15 MB0.31 MB0.61 MB
30 s0.23 MB0.46 MB0.92 MB

Frequently asked questions

Is my song uploaded to a server?

No. The song is read and cut on your device, and the ringtone file is created there.

Is it free to use?

Yes, and the page only cuts, fades and encodes your audio; it adds nothing to the sound.

Can I make a ringtone from a video?

The page opens audio files such as MP3, M4A, WAV, OGG and FLAC. Video files are not on the supported list.

Can I use songs or voice recordings?

Yes, any audio file you have works. A recording from the Online Voice Recorder page, saved as a file, can be opened here too.

What if my song is on Apple Music or Spotify?

The page cannot reach streaming libraries; it only opens files you already have. Apple’s GarageBand route also requires songs from Apple Music to be downloaded, and protected files cannot be used.

How do I set the ringtone on Android?

Copy the saved file to the phone, open its sound settings and choose the file as the phone ringtone. Menu names differ between makers.

How do I install a ringtone on an iPhone?

Apple documents GarageBand on the iPhone: add the clip from the Files app in its Loops browser, drag it to the left edge of the track, then use My Songs, Share and Ringtone. The iPhone Ringtone Maker page lists every step.